首页
公司介绍
产品中心
技术支持
公司新闻
联络我们
设置手册
>>
VPN
>>
远端用户拨入(单机到路由器)VPN设置参考
L2TP--Windows Vista 到 Vigor 路由器(内建工具)
a.
远程拨入用户设定 ( Teleworker ) : [ 以 Vigor2910V 为例]
1.
在Vigor路由器的Web配置主界面,点击
VPN and Remote access Setup > Remote User Profile Setup (Teleworker)
,然后创建用户帐号。
2.
点选
Enable this account
,输入用户名(
username
)和密码(
password
),将
Idle Time
设为0,然后点OK。此时用户可用此帐号建VPN拨入Vigor路由器。
3.
当用户成功拨入路由器后,你可以在
VPN and Remote Access >>Connection Management
里查看此连接的状态。
b. Windows Vista 设定 :
1.
在Connect to a network ,创建一条新连接。请选择“connet to a workplace”。然后点击"Next"。
2.
选择“Use my Internet connect (VPN)“ 作为一个VPN连接。
3.
输入 Vigor 路由器 WAN ip 地址 (202.211.200.241),和此连接的名称。请您选择
"Don't connect now ; just set it up so I can connect later",因为我们稍后需要改换它的属性。
4.
输入 user name 和 password (必须与路由器远端拨入用户设定一致)。
5. 返回到 connect to a network 菜单, 设定连接属性 。
6. 在 Security 栏里,不选 "Require data encryption" 。
7. 在networking 栏里, 选择“ L2TP IPsec VPN”作为VPN通道连接类型。再点击“IPsec Settings”, 然后选择“ select Use certificate for authentication”。 在此例中, 这条通道被设定为一条纯 "L2TP" VPN通道。
8.设定完成。您可以通过L2TP VPN连接到Vigor2910 。
这时您可以Ping 通路由器LAN IP地址来验证VPN连接是否成功。
Ping 结果
已读次数:3408